...
- Make a snapshot of the approved VE runs.
- Upload via the Configuration Manager link to config manager (CM) the locationSets.xml (see folder nwm_VE_smoketest); this file is located under RegionConfigFiles; Provide a description, that this location set is used for smoketest (see Figure 1); this location set is just a temporary one for the smoketests.
Figure 1: Upload via locationSets.xml via Configuration Manager (CM) - Start Client (OC)
- Open Starten workflow; push button Voorbereide taak uitvoeren...; go to folder nwm_VE_smoketest and select one .xml file starting by number one (see Figure 2).
Figure 2: Start batch runs
After the all runs of the selected batch run are finished (check Systeembeheer->Draaiende taken, see Figure 3)), continue with the next file-number.
Figure 3: Check if batch runs are completed The batch-runs contain (REF2015/WS2085) the following runs (see Table 1)
Table 1: Smoketest batch runs for VE
Name Description Expected
run time1_NWM_smoketest_VE_Import.xml All import workflows for all regions < 1 min 2_NWM_smoketest_VE_Hydrodynamic_update.xml The hydrodynamic update runs for RMM (Sobek) < 1 h 3_NWM_smoketest_VE_Hydrodynamic.xml The hydrodynamic forecast runs for Rijn, Maas
( all WAQUA) and RMM (Sobek) with reduced forecast time< 2 h 4_NWM_smoketest_VE_PPHydrodynamic.xml The processioning runs for the WAQUA
calculations of Rijn, Maas< 5 min 5_NWM_smoketest_VE_HydraZoet.xml The HydraZoet runs for IJVD, Rijn, Maas, RMM
for a reduced location set (2 locations Rijn, Maas,
RMM) and Markermeer and IJsselmeer (all locations)
TODO: Extend smoketest to all scenarios< 15 min 6_NWM_smoketest_VE_PPHydraZoet.xml he postprocessing of the HydraZoet runs for a reduced
location set (2 locations Rijn, Maas, RMM)
and Markermeer and IJsselmeer (all locations)< 5 min - After finishing the smoketest re-upload via the Configuration Manager (CM) the locationSets.xml, which is provided in the Configuration under RegionConfigFiles; this file contains the full locations set again for further calculation.
...