The user has to create a surface line with ascending x-value from channel side of the embankment till the dike top at the polder side. The riverside has to be on the left.
To determine the surface line such as the channel depth, the slope angle... etc, shown in the figure below.
D-FLOW SLIDE simplifies the this original surface line from DAM or Ringtoets (WTI) , as can be seen in the figure belowand only use a set of this points.
Please enter your Surface line according this picture by using points B, C, D, G and J
The So, thhe following 5 characteristics points are obligated in D-FlowSlide in the order 1 till 5 with ascending Xx-value.
- Bottom river channel (B)
- Insert river channel (C)
- Dike toe at river (D)
- Dike top at river (G)
- Dike top at polder (J)
...
You can re-order the points, ascending or descending, by clicking on the table header L(enght) of Z(height level)
You get the real order the point, as shown in the drawings, by "Ctrl + click"
It is not impossible to enter a malformed geometry.The program checks on a malformed surface.
The description of these parameters can be found on the page Input parameters.
...