...
In order to create the above mentioned files it is necessary to follow the instructions below: 1.
- Import the branch locations into PCRaster. This is done with the PCRaster general adaptor export, which produces branch0000.000 file.
...
- Copy the X and Y locations from the Branches.xml and make an new irregular grid (XXX_branch_grid) in Grids.xml
...
- Make a new location ID for XXX_branch_grid.
...
- Make XXX_interpolate_grid_to_branch_grid file. This file converts the locationid from XXX_merged to the XXX_branch_grid. And back to the XXX_merged grid, making use of inverse distance interpolation technique. Adapt the search radius to grid size. (= smaller than half a grid cell)
...
- Make general adaptor run file: XXX_PCR_generate_branch_file. This file exports the branch0000.000 file.
...
- Make stream flow direction map.
...
- Export the stream flow direction map with the Modflow general adaptor
...
- Rename stream flow direction asci file into "strdir.asc"
...
- Make initial scalar and ldd map
3.1. use mapattr command to produce scalar.map mapattr scalar.map
number of columns =360
number of rows=240
data type = scalar
projection= y increases from bottom to top
x upperleft corner=400000
y upperleft corner=170000
celllength = 250
3.2. use mapattr command to produce ldd.map mapattr ldd.map
number of colums =360
number of rows=240
data type = ldd
projection= y increases from bottom to top
x upperleft corner=400000
y upperleft corner=170000
celllength = 250
...
- Make a new workflow and adapt the WorkflowDescriptorDescriptors and the ModuleinstanceDescriptors file
...
- Run workflow XXX_PCR_generate_branch_file. This run produces the following files: brances_grid.map, cross_points.map and stream_directions.map
...
- make XXX_QTRIB_ref(Historic) transformation file
...
- adapt interpolation and compare files
...
- adapt Moduledescriptor
...
- and ModuleinstanceDescriptors if still applicable