...
In the Units tab of D-FLOW SLIDE, it is possible to specify the unit of different parameters:
- Fraction: -, %, {^} o/oo or ppm
- Length: m, mm, cm, inch, ft or km
- Tiny length: xxxm
- Angle: deg, rad, grad, tan or cot
- Weigth: kN/m3, N/m3, lb/in3, MN/m3, lb/ft3
- Pressure: kN/m2, N/m2, Pa, kPa, MPa, kN/cm{^}2, psi
- Permeability: m/s, m/min, m/hr, m/day
...
Benchmark name | Fraction unit | Length unit | Tiny length unit | Angle unit | Weigth unit | Pressure unit | Permeability unit |
---|---|---|---|---|---|---|---|
bm4-2a | m | xxxm | deg | kN/m3 | kN/m{^}2 | m/s | |
bm4-2b | % | mm | xxxm | rad | N/m3 | N/m2 | m/min |
bm4-2c | o/oo | cm | xxxm | grad | lb/in3 | Pa | m/hr |
bm4-2d | ppm | inch | xxxm | tan | MN/m3 | kPa | m/day |
bm4-2e | ft | xxxm | cot | lb/ft3 | MPa | m/s | |
bm4-2f | km | xxxm | deg | kN/m3 | kN/cm2 | m/s | |
bm4-2g | m | xxxm | deg | kN/m3 | psi | m/s |
D-FLOW SLIDE inputs
D-FLOW SLIDE results
Group 5: Benchmarks compared with other programs
...
bm5-1a: | bm5-1b: |
bm5-1c: | bm5-1d: |
bm5-1e: | bm5-1f: |
bm5-1g: |
|
D-FLOW SLIDE results
Maximum relative error between SLIQ2D-DOS and D-FLOW SLIDE:
...
Results of SLIQ2D-Windows for bm5-2 - Overview of the unstable points:
D-FLOW SLIDE results
Results between SLIQ2D-Windows and D-FLOW SLIDE are exactly the same for all calculated parameters, as shown in the table below.
...