| scrollbar |
|---|
| Table of Contents |
|---|
...
KFlows Display
KFlows is a very specific module that is applied to monitor target flows over a water day at a specified site. In NFFS the model is applied only for Thames region. The KFlows display is the front end (user interface) of the KFlows module. The KFlows module may be run without an active connection to the network or even a Master Controller.
...
KFlows can be used in two working modes:
- _Current day mode
_ This is the 'forecasting mode'
- Historical mode
This mode allows the user to view flows and trends of previous water days
1.1Anchor _Toc172823888 _Toc172823888 Anchor _Toc140564213 _Toc140564213 Anchor _Toc132166534 _Toc132166534
KFlows Calculations
The KFlows module performs the following calculations:
- First the average of the last 8 observed values (last 2 hours) is determined.
- This average (the current trend) is used to extrapolate the observed timeseries for the whole water day
- From this time series a running mean is determined that is displayed in the graph
- The end of day mean is determined and (in case of the workflow) stored in a daily timestep series
- The display can also use a what-if scenario for the rest of day flow. It then determines the amount of water needed to reach the target flow
1.2 anchor_Toc172823889 _Toc172823889 Anchor _Toc140564214 _Toc140564214 Anchor _Toc132166535 _Toc132166535
Current day mode
After opening the selected gauge the module will get the data and perform the calculations. If not enough data points (the number of points used is presently fixed at 8) are present between the current time and the configured start of the water day the calculation will use less points and a warning message will be printed in the status bar.
Using the controls on the bottom left part the target flow and the what-if flow for the rest of the day may be adjusted. After adjusting any of these, the calculations will be updated immediately.
...
The save target button allows the user to save the target flow for that day. Saved target flows are used in the historical mode of the display.
anchor
Historical mode
The historical mode can be selected using the historical model toggle. After selecting this toggle the drop down box can be used to select a specific water day. The display will show recorded flow, target flow and the running mean trend for that day.
1.3 