...
The basic of the program is the Surface line.
The user have has to add create a surface line from Left to Right
The 5 characteristics point are obligated in the right order!!!
with ascending x-value from channel side of the embankment till the dike top at the polder side.
The riverside has to be on the left as shown in the figure below.
The original surface line as used in DAM or Ringtoets (WTI) contains a whole set of characteristics points. Flow Slide needs a subset.
Please enter your Surface line by using points B, C, D, G and J
The following 5 characteristics points are obligated in D-FlowSlide with increasing x-value.
- Bottom river channel (B)
- Insert river channel (C)
- Bottom river channel
- Insert river channel
- Dike toe at river (D)
- Dike top at river (G)
- Dike top at polder (J)
Input screen for the coordinates L and Z and the characteristic points
The description of these parameters can be found on the page Input parameters.
You may, of course add additional points to describe the real surface line.
By clicking on the table header L(enght) of Z(height level), you can only filter the points, but not order them.
The program checks on a malformed surface.
Messages will be displayed in the window "Validation messages".