...
Set of rules to allow selection of lows from an input time series.
This transformation will select only the lows which occur within the defined gap in time between lows.
...
Input
Timeseries
Options
Requirements for definitions of low selections using gaps to define independence are:
...
- An attribute "totalNumber" must be defined. The value attribute defines the maximum number of lows to consider.
Output
Timeseries containing the selection of lows
Configuration example
| Code Block | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
<transformation id="independent lows function test">
<selection>
<independentLows>
<inputVariable>
<timeSeriesSet>
<moduleInstanceId>SelectionIndependentLowsFunctionTest</moduleInstanceId>
<valueType>scalar</valueType>
<parameterId>H.tidal</parameterId>
<locationId>H-2010</locationId>
<timeSeriesType>external historical</timeSeriesType>
<timeStep unit="minute" multiplier="15"/>
<relativeViewPeriod unit="day" start="0" end="365"/>
<readWriteMode>editing visible to all future task runs</readWriteMode>
</timeSeriesSet>
</inputVariable>
<gapLengthInSec>2700</gapLengthInSec>
<totalNumberBeforeT0>3</totalNumberBeforeT0>
<totalNumberAfterT0>4</totalNumberAfterT0>
<skipJustBeforeT0>2</skipJustBeforeT0>
<skipJustAfterT0>2</skipJustAfterT0>
<outputVariable>
<timeSeriesSet>
<moduleInstanceId>SelectionIndependentLowsFunctionTest</moduleInstanceId>
<valueType>scalar</valueType>
<parameterId>H.updated</parameterId>
<locationId>H-2010</locationId>
<timeSeriesType>external historical</timeSeriesType>
<timeStep unit="nonequidistant"/>
<relativeViewPeriod unit="day" start="-5" end="15"/>
<readWriteMode>add originals</readWriteMode>
</timeSeriesSet>
</outputVariable>
</independentLows>
</selection>
</transformation>
|
...
- The time between two local minima (lows) should be at least 2700 seconds or 45 minutes.
- Only the first last three lows before T0 and the first four lows after T0 are considered.
- The first two lows of the last three lows just before T0 are skipped, leaving only the third last one.
- Similarly the first two lows just after T0 are skipped, leaving the third and fourth ones.
forecastLoopSearchPeriod
When a forecastLoopSearchPeriod is configured the transformation will be repeated for each external forecast found in the defined period.
This will only work when the <inputVariable> and <outputVariable> are external forecasts, the output variable for each execution will get the same external forecast time as the input.
For some general info see ForecastLoop
| Code Block | ||||
|---|---|---|---|---|
| ||||
<transformation id="SelectionIndependentLowsMultipleForecastsTest">
<selection>
<independentLows>
<inputVariable>
<variableId>forecast</variableId>
</inputVariable>
<forecastLoopSearchPeriod unit="week" start="-5" end="0"/>
<gapLengthInSec>2700</gapLengthInSec>
<totalNumberBeforeT0>0</totalNumberBeforeT0>
<totalNumberAfterT0>0</totalNumberAfterT0>
<skipJustBeforeT0>0</skipJustBeforeT0>
<skipJustAfterT0>0</skipJustAfterT0>
<outputVariable>
<variableId>outputForecast</variableId>
</outputVariable>
</independentLows>
</selection>
</transformation> |