...
- add sheet diff_sim_inp to your spreadsheet
- carry out changes in sheet 'runMF':
- change location set for import of QSRC_GW from file XXX_QSRC_GW_TimeSeries.xml from XXX_wells_all to XXX_wells_singles_and_childs
- add import of QSRC_GW from file XXX_QSRC_GW_TimeSeries_MultiLayer.xml for XXX_wells_parents
- check if QSRC_GW from file XXX_QSRC_GW_merged_MapStacks.xml is imported for the merged layer
- carry out changes in sheet 'interpolate':
- add interpolation of QSRC_GW from merged layer to location set 'XXX_parents_and_singles'
- change the interpolation of QSRC_GW for GWunits from locSet_in=XXX_wells_all to loc_ID=merged layer. Change ValType_in to grid
- carry out changes in sheet 'compare':
- add comparison of QSRC_GW created in 3. for location set 'XXX_parents_and_singles'
- run macro 'Write_diff_sim_inp_XMLfiles'
- run macro 'Write_runMF_XMLfiles' (make sure you run the macro 'remove' afterwards)
- run macro 'Write_interpolate_XMLfiles'
- run macro 'Write_compare_XMLfiles'
- Check the contents of the created files. It might be wise to validate with an XML-validation tool.
- Copy the files which are OK to your configuration --> \Config\ModuleConfigFiles
...
add the following module instance sets to moculeinstancesetsmoduleinstancesets.xml (in Config/RegionConfigFiles) for all relevant scenarios and models
...
- add location set XXX_wells_parents_and_singles containing the two location sets XXX_wells_parents and XXX_wells_singles
- Make sure that the order of the location sets in location set XXX_wells_parents is as follows (otherwise the total for the super parents will not be displayed):
1) XXX_wells_normal_parents
2) XXX_wells_super_parents - Make sure all locations which refer to super parents are childs or normal parents (no singles!)
- Make sure there are no child locations in the single location set !!!
- Make sure all single locations are listed in the single location set
- Skip this step for now (this step is in progress) "Update locations spreadsheet"
...