Wiki Markup |
---|
{import:NavigationMenu} |
Group 4: Benchmarks generated by the program itself
This section contains This section should contain tests for which the reference results are generated with D-FLOW SLIDE.
4.1 Test on the level indicator
Description
To check that the level indicator is correctly inputted in D-FLOW SLIDE, the results of the two following calculations should lead to the same results:
- Benchmark 4-1a uses the same input as benchmark 1-1a, refer to paragraph 1.1 in group 1.
- Benchmark 4-1b uses the same input as benchmark 4-1a except that the Z-coordinates of the geometry are shifted by -20 m so that all points have a negative Z-coordinate.
D-FLOW SLIDE results
4.2 Test on the units
Description
In the Units tab of D-FLOW SLIDE, it is possible to specify the unit of different parameters:
- Fraction: -, %, o/oo or ppm
- Length: m, mm, cm, inch, ft or km
- Tiny length: xxxm
- Angle: deg, rad, grad, tan or cot
- Weigth: kN/m3, N/m3, lb/in3, MN/m3, lb/ft3
- Pressure: kN/m2, N/m2, Pa, kPa, MPa, kN/cm2, psi
- Permeability: m/s, m/min, m/hr, m/day
To test the correctness of the convertion , 7 benchmarks are created using the following set of units:
...
Benchmark name
...
Fraction unit
...
Length unit
...
Tiny length unit
...
Angle unit
...
Weigth unit
...
Pressure unit
...
Permeability unit
...
bm4-2a
...
m
...
xxxm
...
deg
...
kN/m3
...
kN/m2
...
m/s
...
bm4-2b
...
%
...
mm
...
xxxm
...
rad
...
N/m3
...
N/m2
...
m/min
...
bm4-2c
...
o/oo
...
cm
...
xxxm
...
grad
...
lb/in3
...
Pa
...
m/hr
...
bm4-2d
...
ppm
...
inch
...
xxxm
...
tan
...
MN/m3
...
kPa
...
m/day
Currently, no benchmarks are related to this group.
...
bm4-2e
...
ft
...
xxxm
...
cot
...
lb/ft3
...
MPa
...
m/s
...
bm4-2f
...
km
...
xxxm
...
deg
...
kN/m3
...
kN/cm2
...
m/s
...
bm4-2g
...
m
...
xxxm
...
deg
...
kN/m3
...
psi
...