Tutorial
Introduction
This tutorial guide describes how a test can be set up using the STREAM Concept and can be carried out using the STREAM Library.
Overview
Step | Description |
---|---|
A Testdefinition describes the procedure of a test. This is an XML document that can be created using the Testdefiner. | |
Choose a Testdefinition and create an empty test. | |
Enter the data required in the setup phase, as general project and test information and coordinate systems, sensor locations and sensor calibrations. | |
Enter the data required in the measurement phase, meter readings. | |
Perform calculations on measurement data. | |
Perform Reporting Report phase | Collect measurement and analysis data and present them. |
Store the results. |
Info | ||
---|---|---|
| ||
An example of these steps (except the first and last), can be found in |
Scenarios
Scenario | Desciption |
---|---|
| |
|
Miscellaneous
Step | Description |
---|---|
Installing the software on a system. | |
Some variables can be set to a default value. | |
Most companies report their data within a specified frame. | |
For a type of test or a group of tests a plot layout can be created in which during the test the data can be plot very easily during the test. | |
Transducers are placed on a certain location, relative to a coordinate system. | |
Transducer readings can be converted to physical values by defined Calibrations. | |
StreamCheckFiles | Tool to check a batch of datafiles against the Testdefinition |