Group 4: Benchmarks generated by the program itself
This section contains tests for which the reference results are generated with D-FLOW SLIDE.
4.1 Test on the level indicator
Description
To check that the level indicator is correctly inputted in D-FLOW SLIDE, the results of the two following calculations should lead to the same results:
- Benchmark 4-1a uses the same input as benchmark 1-1a, refer to paragraph 1.1 in group 1.
- Benchmark 4-1b uses the same input as benchmark 4-1a except that the Z-coordinates of the geometry are shifted by -20 m so that all points have a negative Z-coordinate.
D-FLOW SLIDE results
4.2 Test on the units
Description
In the Units tab of D-FLOW SLIDE, it is possible to specify the unit of different parameters:
- Fraction: -, %, o/oo or ppm
- Length: m, mm, cm, inch, ft or km
- Tiny length: xxxm
- Angle: deg, rad, grad, tan or cot
- Weigth: kN/m3, N/m3, lb/in3, MN/m3, lb/ft3
- Pressure: kN/m2, N/m2, Pa, kPa, MPa, kN/cm2, psi
- Permeability: m/s, m/min, m/hr, m/day
To test the correctness of the convertion , 7 benchmarks are created using the following set of units:
Benchmark name |
Fraction unit |
Length unit |
Tiny length unit |
Angle unit |
Weigth unit |
Pressure unit |
Permeability unit |
|---|---|---|---|---|---|---|---|
bm4-2a |
m |
xxxm |
deg |
kN/m3 |
kN/m2 |
m/s |
|
bm4-2b |
% |
mm |
xxxm |
rad |
N/m3 |
N/m2 |
m/min |
bm4-2c |
o/oo |
cm |
xxxm |
grad |
lb/in3 |
Pa |
m/hr |
bm4-2d |
ppm |
inch |
xxxm |
tan |
MN/m3 |
kPa |
m/day |
bm4-2e |
ft |
xxxm |
cot |
lb/ft3 |
MPa |
m/s |
|
bm4-2f |
km |
xxxm |
deg |
kN/m3 |
kN/cm2 |
m/s |
|
bm4-2g |
m |
xxxm |
deg |
kN/m3 |
psi |
m/s |
