{import:NavigationMenu}
h1. 1. Global check (VTV-2006)
h3. 1.1 Check on liquefaction
The global check for liquefaction as implemented in *D-Flow Slide* is shown in the schema below. It is based on the assessment schema described in VTV-2006.
!Figuur globale toetsschema nieuw.jpg|width=800!
Figure 1: Assessment schema for liquefaction
h5. Step 1 - Geometrical check: damaging criterium liquefaction
The damaging criterion is met if at the so-called assessment level is situated within the slope (i.e. on landward side of) the so-called observation profile, in accordance with Annex 9.4 of the VTV-2006.
h6. 1) Determination of the observation profile
The required margin (the horizontal part from the outside toe of the dike) depends on the presence of a revetment and is determined by the relation:
M = 2 H{~}vw~ + 1.5 (H - H{~}vw~) in case no revetment is present
M = Max \[ M{~}bestorting~ ; 2 H{~}vw~ + 1.5 (H - H{~}vw~) \] in case a revetment is present
where H is the channel depth, H{~}vw~ is the thickness of the sensitive layer and M{~}bestorting~ is the horizontal projection of the length of the slope protectionrevetment.
In case no slope protection is present, if over the entire channel depth softening sensitive sand is present, this margin is thus equal twice the fictive channel depth (M = 2 H).
The inclined part of the observation profile in line with the horizontal portion. The inclinaison of the slope depends on the channel depth:
* 1:15 if the fictive channel depth is less than 40 m (H < 40 m)
* 1:20 if the fictive channel depth is more than 40 m (H ≥ 40 m)
h6. 2) Determination of the assessment level
The assessment level is the lower boundary of the liquefiable sand layer, but has a minimum and maximum of H/3 and H/2 above the bottom of the channel respectively.
h6. 3) Comparison of the observation profile with the existing profile at the assessment level
The damaging criterium is not met if the liquefaction point S{~}ZV~ is situated landwards of the observation point S{~}sign~.
where S{~}sign~ is the intersection point between the observation profile (from the foreshore) and the assessment level and
S{~}ZV~ is the intersection point between the existing profile and the assessment level.
h5. Step 2: Artificially underwater installed and non-compacted sandy foreshore?
By lack of information, *D-FLOW SLIDE* assumes that no artificially underwater installed and non-compacted sandy foreshore is present (step 2 of the Global check).
h5. Step 3: Is the dumping criterion satisfy?
Directly in front of the toe of the dike or on the outside of the toedumping or to the outward end of a dumping, the slope 1:2.5 may not be cut by the profile.
h5. Step 4: Is liquefaction possible on the basis of geometry?
The occurrence of a liquefaction is possible if one of the two following conditions is met:
- The average slope is steeper than or equal to 1:4, over a height of at least 5 m;
- The total slope (channel edge-channel bottom) is on average steeper than or equal to 1:7.
h5. Step 5: Are there any sensitive to liquefaction layers present? |