This page contains a list of configuration checks. Please follow the checks below to check your configuration of the open archive.
1) Verify the maximum number of file descriptors and vm.max_map_count (Linux only)
Both the maximum number of file descriptors and the vm.max_map_count needed to be set correctly when you run the archive on a linux-system.
Deltares Open Archive Installation path - 2018.02 and later(linux only, tune the file system)
2) Elastic settings
Elastic goes by default to read-only mode when the available disk-space is lower then 5%. In addition elastic will not switch back to write mode when disk space is made available again.
It is therefore recommended to replace these default settings. Read in the following page Catalogue read-only mode more about how this can be done.
3) disable indexing forecast time series
By default the forecast time series are also indexed in the catalogue. However this not needed for most archive systems. If possible this indexing should be disabled. This will greatly increase the performance of the harvester.
Read more about this topic at Speed up harvester
